Ramm Tactical P365 XMACRO Trigger, *NON G STAMP*
RAMM Tactical P365 XMacro Trigger kit for non G stamped FCUs, with a 4140 steel leverage trigger, 3.5 to 4.5 lb pull and adjustable post travel.
Read more ↓2 in stock
Description
*THIS TRIGGER KIT IS FOR FCU's THAT ARE NOT STAMPED WITH "G"*
The RAMM Tactical P365 XMacro Trigger is a drop-in fire control upgrade for Sig Sauer P365 pistols built on frames whose FCU is not stamped with a "G". It replaces the factory trigger group with a leverage-geometry design that lightens the pull to roughly 3.5 to 4.5 pounds, trims pre-travel, and shortens reset without stepping outside the factory spring setup that keeps ignition consistent.
Shooters who carry or compete with a P365, P365 XL, or XMacro and want a cleaner break will see the biggest difference here. Installation calls for familiarity with striker-fired pistol disassembly, and the kit arrives with the hardware needed to complete the job.
RAMM Tactical P365 XMacro Trigger Features
- Revised leverage geometry drops pull weight into the 3.5 to 4.5 pound range while keeping the break predictable from shot to shot
- Reduced pre-travel and a shortened post-travel path put the wall closer to the finger and bring the reset back quickly
- Post-travel set screw, adjusted with a 0.9 mm hex, lets you tune rearward travel without cutting into the movement needed for reliable ignition
- 4140 alloy steel trigger with a Cerakote finish stands up to wear and holds its surface through long round counts
- Factory striker and mainspring components stay in service, which keeps primer strikes full strength
- Ergonomic trigger pad gives the finger a consistent reference point, helping repeat the same press under speed
Specifications
- Condition: New
- Manufacturer: RAMM Tactical
- Model: P365 XMacro Trigger Kit, non "G" stamped FCU
- Operating System: Striker-fired fire control replacement, retains factory springs
- Safety System: Retains factory trigger safety plunger and drop safeties, uses factory thumb safety lever where equipped
- Finish Type: Cerakote over 4140 alloy steel
- Included Accessories: Leverage trigger, proprietary sear, proprietary trigger pin, sear spring, trigger return spring, safety plunger spring, proprietary takedown lever, RAMM Tactical slide end cap, blue Loctite, and installation hardware
- Additional Notable Specs: Approximately 3.5 to 4.5 lb pull weight, pre and post travel adjustment via 0.9 mm hex set screw, not compatible with MCarbo titanium striker assemblies
Specifications
Related Products
-
RAMM TACTICALRamm Tactical 4lb P365 Trigger Spring Kit
-
RAMM TACTICALRamm Tactical P365 XMACRO Trigger, *WITH G STAMP*
-
TRIGGER SHARKTrigger Shark Gen5-6 Extended Slide Stop 9mm
-
BUL ARMORYBUL ARMORY LINK TRIGGER BOW | BLACK
-
BUL ARMORYBUL ARMORY LINK TRIGGER BOW | SILVER
Reviews
There are no reviews yet.