Ramm Tactical P365 XMACRO Trigger, *WITH G STAMP*
3 in stock
Description
* THIS TRIGGER KIT IS FOR FCUs STAMPED WITH A "G" *
The RAMM Tactical P365 XMacro Trigger is a drop-in fire control upgrade for the Sig Sauer P365 family, built specifically for fire control units stamped with the letter "G". It replaces the factory trigger, sear, and related small parts with a leverage-optimized assembly that cuts pull weight to roughly 3.5 to 4.5 pounds while trimming pre-travel and post-travel. Shooters who like the P365 platform for carry or competition but want a cleaner break and a shorter, more positive reset are the target audience here.
RAMM's design keeps the factory striker and mainspring in the system, so ignition energy stays where Sig set it and light primer strikes are not traded away for a lighter pull. The trigger body is machined from 4140 alloy steel and Cerakoted. Installation calls for standard striker-fired disassembly knowledge, and the kit uses your existing thumb safety lever if your pistol is so equipped. Verify your FCU carries the "G" stamp before ordering, since that marking determines fitment.
RAMM Tactical P365 XMacro Trigger Features
- Reworked leverage geometry brings the pull into a 3.5 to 4.5 pound range for a lighter, more predictable break
- Reduced pre-travel and a post-travel set screw let you tune the trigger for a short, repeatable reset without cutting into the travel needed for ignition
- 4140 alloy steel construction with a Cerakote finish stands up to wear from heavy round counts and holster use
- Runs on factory springs and retains the factory striker setup, preserving consistent ignition and avoiding light primer strikes
- Factory trigger safety plunger, drop safeties, and thumb safety compatibility stay intact
- Ergonomic trigger pad gives a flatter, more consistent finger contact point through the press
Specifications
- Condition: New
- Manufacturer: RAMM Tactical
- Model: P365 XMacro Trigger Kit, "G" Stamp FCU
- Operating System: Striker-fired fire control upgrade, uses factory striker and mainspring
- Safety System: Retains factory trigger safety plunger and drop safeties, works with factory thumb safety lever
- Finish Type: Cerakote over 4140 alloy steel
- Included Accessories: Leverage trigger, proprietary sear, proprietary trigger pin, sear spring, trigger return spring, safety plunger spring, proprietary takedown lever, RAMM Tactical slide end cap, blue Loctite, and installation hardware
- Additional Notable Specs: Approximately 3.5 to 4.5 lb pull weight, pre- and post-travel adjustment via 0.9 mm hex set screw, fits P365 variants including California-compliant models, not compatible with MCarbo titanium striker assemblies
Specifications
Related Products
-
RAMM TACTICALRamm Tactical P365 XMACRO Trigger, *NON G STAMP*
-
BUL ARMORYBUL ARMORY LINK TRIGGER BOW | BLACK
-
BUL ARMORYBUL ARMORY LINK TRIGGER BOW | SILVER
-
TIMNEY TRIGGERSTIMNEY ALPHA COMPETITION GLOCK GEN 6 TRIGGER 3LB RED
Reviews
There are no reviews yet.